A switch port can work in two modes: access and trunk. In access mode, it works with a single VLAN. If you connect an end device to a switch port, you do not need. Cisco switches can be configured with a special IP address known as the switch virtual interface (SVI). If the VLAN 1 SVI is assigned an IP address, by default, all ports on VLAN 1 have. This video will demonstrate the Configure procedure of Access Mode Interfaces for S-Series Switch. Please see the installation guide for the switch. Cisco NX-OS supports only IEEE 802. Step 2: Create. My question is about the output of S1#sh int gig1/1 switch (same output on the other interfaces and switches) If I would add switchport access vlan 40 to all gig interfaces.
[pdf] This layer usually incorporates Layer 2 switches and access points that provide connectivity between workstations and servers. You can manage access control and policy, create separate collision domains, and implement port security at this layer. For example, a switch that provides access-layer functionality is called an access switch, a switch that operates in the distribution layer is known as a distribution switch, and a switch that operates in the core layer is called a core switch. This layer serves as the network's outermost boundary and the gateway through which all data must pass. Selecting the right switch type has a direct impact on network scalability, performance, and management efficiency.
[pdf] 
