For all fiber trunk cables and fiber jumpers, which do not run in con-duit, we recommend fixing them at intervals of 0,80 -1 meter vertically and 1 meter horizontally. Only clamps with appropriate diameter are used to fix the cable to the structure. Correct installation of fiber optic cable is one of the first and most important steps to ensure that the optical fiber network performs properly. Always handle the equipment with the adequate care. Install cable always with factory-mounted installation tubes / pulling sock. Applications Engineering Note (AE Note) addresses the maximum er must know the maximum long-term tensile load of the cable since this is the tensile load the cable can wi stand over time. Failure to do so can result in life-threat t truck or on a ladder so that it cannot fall.
[pdf] Install vertical, unfilled, loose tube cables with loops to prevent the fiber from slipping to the bottom of a vertical run. Check continuity and attenuation. Therefore the routing of fiber optic cables is less critical than for copper cables. This is due to several potential risks and complications that can arise from such an arrangement. You should pull on the fiber cable strength members only! Never exceed the maximum pulling load rating.
[pdf] The most fundamental acceptance test for any fiber optic cable is an insertion loss measurement using a light source and power meter: Connect the light source to one end of the link. Connect the power meter to the far end. Ensure it supports the correct wavelength (850nm for multimode fiber, 1310nm or 1550nm. Insertion loss is usually shortened to IL, and the unit of measurement for insertion loss is dBm.
[pdf] With a fiber-optic cable, many optical waveguides are bundled together. They take on the role of a transmission medium in a network. The transmission is implemented through photons, i.e., optical light si.
[pdf] Several types of tray are used in different applications. A solid-bottom tray provides the maximum protection to cables, but requires cutting the tray or using fittings to enter or exit cables. A deep, solid enclosure for cables is called a cable channel or cable trough. A ventilated tray has openings in the bottom of the tray, allowing some air circulation around the cables, water drainage, and allowing some dust to fall through the tray. Small cables may exit the tray throug.
[pdf] 
